Editing An Ip Address - Brocade Communications Systems 8 Administrator's Manual

15
Setting up iSCSI Target Gateway services
•
The iSCSI Port Group tab allows you to configure iSCSI ports, display session details on a port, and
show the port statistics. It also allows you to view and configure the IP interface and routes that are
located on the IP Interface tab. You can edit or delete the IP address, but you cannot add any
additional IP addresses to this interface.
When you select the switch in the left pane, the right pane lists the tasks you can perform on that
switch in relation to one of the GbE ports.
When you select one of the GbE ports, you can perform the same tasks listed previously: view and
capture statistics related to the port, add or delete IP addresses, add or delete IP routes, view
current sessions, and view the iSCSI statistics in brief.
If an IP address or IP route is already configured on the GbE port, then it is not editable as any edits
disrupt any iSCSI traffic.
Configuring the IP route is optional because when an IP address is set up, a route is automatically
set up as well.
Use the following procedure to configure the IP interface.
1. Open the iSCSI Target Gateway Admin module as described in
2. Select the iSCSI Port tab.
3. In the left pane, select the GbE port to use.
4. Select the IP Interface subtab and click Add.
5. Enter the IP address and subnet mask.
6. Enter the MTU size or accept the default MTU size, and click Add.

Editing an IP Address

Use the following procedure to edit an IP address.
1. Launch the iSCSI Target Gateway Admin module as described in
2. Select the iSCSI Port tab.
3. From the left pane, select the GbE port to use.
4. Select the IP Interface subtab and select the item on the tab.
5. Click Edit.
6. Click OK when you receive the Warning dialog box.
7.
8. Enter the MTU size or accept the default MTU size, and click OK.
190
DRAFT: BROCADE CONFIDENTIAL
Configure the IP route for the iSCSI port.
Gateway Admin Module" on page 188.
Gateway Admin Module" on page 188.
Enter the subnet mask.
NOTE
To change the IP address, delete the current IP address and recreate it. You are not allowed to
create an additional IP address for this interface, because there can be only one IP address
per interface.
"Launching the iSCSI Target
"Launching the iSCSI Target
Web Tools Administrator's Guide
53-1001772-01