Portcfglosstov - Brocade Communications Systems 8 Command Reference Manual

2

portCfgLossTov

portCfgLossTov
Enables or disables de-bouncing of signal loss for front end ports.
Synopsis portcfglosstov [slot]/port mode
Description Use this command to enable or disable the de-bouncing of loss of signal for 100 ms for front end
ports. Use portCfgShow to display the current setting.
If executed without operands, the command prints the usage.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
On a chassis, this command must be executed on the active CP.
Operands This command has the following operands:
slot
port
mode
Examples To enable the configuration on port 1/5 and to display the configuration:
654
For bladed systems only, specifies the slot number of the port to be
configured, followed by a slash (/).
Specifies the port to be configured, relative to its slot for bladed systems. Use
switchShow to list valid ports.
Specify 1 to enable the configuration. Specify 0 to disable the configuration.
switch:admin> portcfglosstov 1/5 1
switch:admin> portcfgshow 1/5
Area Number:
Speed Level:
Fill Word:
AL_PA Offset 13:
Trunk Port
Long Distance
VC Link Init
Locked L_Port
Locked G_Port
Disabled E_Port
Locked E_Port
ISL R_RDY Mode
RSCN Suppressed
Persistent Disable
LOS TOV enable
NPIV capability
QOS E_Port
Port Auto Disable:
Rate Limit
EX Port
Credit Recovery
F_Port Buffers
NPIV PP Limit:
CSCTL mode:
5
AUTO(HW)
0(Idle-Idle)
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
AE
OFF
OFF
OFF
ON
OFF
126
OFF
Fabric OS Command Reference
53-1001764-02