Mfic System Messages - Brocade Communications Systems 8 Reference

MFIC System Messages

MFIC-1001
Message
<timestamp>, [MFIC-1001], <sequence-number>,, ERROR, <system-name>, failure at
sysmod_scn registry rc= <failure reason>
Probable Cause Indicates the system is temporarily out of resources.
Recommended No action is required; this message is often transitory.
Action
If the message persists, run a switch reboot or an haFailover command (if applicable).
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity ERROR
MFIC-1002
Message
<timestamp>, [MFIC-1002], <sequence-number>,, INFO, <system-name>, Chassis FRU
header not programmed for switch NID, using defaults (applies only to FICON
environments).
Probable Cause Indicates that custom switch node descriptor (NID) fields have not been programmed in nonvolatile
storage. The default values are used. The Switch NID is used only in the following SB ELS frames:
Request Node Identification Data (RNID) and Registered Link Incident Record (RLIR).
The use of SB-3 link incident registration and reporting is typically limited to FICON environments.
Recommended No action is required if SB-3 link incident registration and reporting is not used by the host or if
Action default values are desired for the switch node descriptor fields.
Severity INFO
MFIC-1003
Message
<timestamp>, [MFIC-1003], <sequence-number>,, WARNING, <system-name>, Effective
Insistent domain ID for the fabric changed from <state> to <state>
Probable Cause Indicates that one or more switches joined the fabric with an insistent domain ID (IDID) mode
setting that is different from the current effective IDID mode for the fabric. This message also
occurs when the IDID for the fabric has been turned on or off. The possible values for the state are
"On" and "Off".
Fabric OS Message Reference
53-1001767-01
Chapter
66
429