Playback; Playback Recorded Images - Panasonic WJND400 - NETWORK DISK RECORDER Operating Instructions Manual

Playback

Playback recorded images

Play back recorded images. There are three ways to play recorded images, specify a time and date, specify search conditions, or select a disk.
1
Click the [HDD] tab.
Note:
• The audio with the images is played when single screen is displayed.
• The audio from the upper-left camera channel is played when multiscreen are displayed.
• Play the most recent images the first time images are played after logging in. The default setting is to start playing 30 seconds before the
most recent images. The settings for the playback start schedule are shown below.
5s/10s/30s/1min/5min
For information about settings, contact your system administrator.
• If multiple browsers and viewers are running at the same time, audio playback may not be correct.
To play back the audio correctly, run either the browser or the viewer only.
• Playback may slow down or briefly stop if the load on the main unit is too large (many cameras are connected, many images are being
played or shown etc.).
• When playing images on multiscreen, images will be played with frame dropping.
• When playing image recorded a different recording rate (one at a higher rate and the other at a lower rate) simultaneously on multiscreen,
the difference between the displayed time for each channel will be widen.
• To play SD memory data, search for a recording event and select the images from the rec event list (page 24).
• Image and audio sometimes may not be synchronized.
• Click the [Cam. select] button while playing back images, click a camera title to change the camera channel.
• You can change to the multiscreen display by clicking the [Multiscreen select] button during playback.
• Click the camera title when viewing miltiscreen to view the clicked image on a single screen.
2
Click the [PLAY] button.
Plays recorded images. "Playback operation [Step 1]" is
displayed in the status display area.
Playback will start from the finish point (time and date) of the
last playback.
3
On the [HDD] tab, click the [STOP] button.
"Playing [Step 1]" disappears from the status display area
and playback is stopped.
• The live image from the camera is displayed in the Image
display.
19