System Setup; Keyboard Type - Honeywell HJZTP User Manual

3.3 SYSTEM SETUP

Before using the HJZTP keyboard it must be set-up to meet the systems requirements.
There are three aspects of the keyboards set-up which need to be set. These are
keyboard type, DVR / multiplexer / camera connection, dome protocol.
Pressing and holding the 'lock' key and entering XXXX (code not shown) on the
numeric keypad, will display the keyboard setup menu, as shown below:
A U X
K E Y B R D
'KEYBRD' will be flashing. Use the joystick left and right or the 'F3' ('◄' ) and 'F4' ('►' )
keys (or 'camera' and 'preset' buttons), to select the required option. Pressing 'aux' will
then enter the required menu.

3.3.1 Keyboard Type

The keyboard can be set as a master keyboard or one of 3 slave keyboards. The default
setting is as a master keyboard.
If there is only one keyboard in the system or the keyboard is to be the one which is
connected to the domes and DVRs / multiplexers, then the keyboard must be set as a
master keyboard. Other keyboards in the system must be set as slaves. Up to three
slave keyboards can be connected to the master keyboard, each slave keyboard must
have a different slave keyboard number.
To set the keyboard type, select 'KEYBRD' in the keyboard setup menu. The following
menu will be displayed:
A U X
M S T R
If the keyboard has not been set-up before 'MSTR' will be flashing, otherwise the
keyboards current setting will be flashing. Use the joystick left and right or the 'F3' ('')
and 'F4' ('') keys (or 'camera' and 'preset' keys) to select the required option, then
press 'aux'. The keyboard type selected will be displayed for 1 second to confirm the
selection, as shown below (n is the Slave number):
Or:
Once the required keyboard type has been selected, press 'lock' to exit the menu.
Rev. 1.01
= S E T
D V R /
= S E T
S L V 1
S L A V E n
M A S T E R
13
L O C K =
M U X P R T C L
L O C K =
S L V 2 S L V 3
K E Y B O A R D
K E Y B O A R D
E N D
E N D
900.0570
8-Sept-05