Press this button to arm when you are staying home and do not
expect anyone to use the entrance door. Your installer may have
configured NIGHT Mode differently; have him/her describe the
actual settings of this mode.
Check this circle when you want to arm more than one partition.
When Multi-Partitions is checked, all partitions within the system
can be armed at one time (if the user is so authorized). When the
Arm Multi-Partitions circle does not contain a check mark, each
partition must be armed individually. Note: This option may not
be shown for some single partition systems.
Press this button for more Security, Lighting, and TouchCenter
The "Arming" screen also displays an Icon(s) if a system trouble(s)
occurs. The system trouble Icon is displayed to the left of the Panic
button. If a trouble Icon is shown, contact your alarm company. The
following Icons may be shown as applicable to your system:
AC Loss – The system is not receiving AC power.
Bell Failure – The system bell or siren has a problem. Note: This Icon
will be displayed when interfacing with residential panels only.
Expander Failure – The system has a failure in an expansion module.
Low Battery – The system battery, that powers the system during an
AC power loss, is low.
LRR Supervision Failure – The Long Range Radio or Alarmnet –I
used to communicate with the central station has a supervision
failure. Note: This Icon will be displayed when interfacing with
residential panels only.
Pager Failure – The system cannot communicate with an assigned
Phone Line 1 Failure – The system is not able to communicate with
the central monitoring station over the primary phone line.
Phone Line 2 Failure – The system is not able to communicate with
the central monitoring station over the secondary phone line.
Wireless Failure – The system is not able to communicate with its
About the TouchCenter (Cont'd)