Honeywell ADEMCO 6160RF User Manual

KEYPAD DISPLAYS AND LEDS
The 6160RF has the following features:
• Large backlit, 2-line, 32-character alphanumeric
LCD.
• 16 large telephone-style backlit keys located behind a
decorative door that swings down to provide access to
the keys.
• System numerals, imprinted in large type on the keys
for easy identification. System functions appear below
the keys on the keypad.
The following table shows the LEDs and their functions:
LED
ARMED Lights when the system is armed in any mode.
(Red)
READY Lights when the system is ready to be armed (no
zone faults are present).
(Green)
FUNCTION KEYS AND LABELS
The function keys are continuously backlit for ease in
use. (Check the User Guide that accompanies the control
panel for detailed instructions on the use of these keys.)
Function Keys - The function keys include keys for
panic alarm activation. The panic alarms are activated
by pressing key pairs [1] & [*], [3] & [#], or [*] & [#], or
a Special Function Key.
TROUBLESHOOTING
The error messages listed in the following table cause the keypad to produce a single ding tone. The table describes the
error messages and the corrective actions.
Display
Low Bat (with Zone No.)
Open Ckt
Check 100

User Guide

Function
SPECIAL
FUNCTION
KEYS
PANIC KEY PAIR
6160RF Keypad/Transceiver (front door removed)
1. Replace the battery if the wireless transmitter has a replaceable battery.
2. Replace the transmitter if the wireless transmitter does not have a replaceable battery.
Contact your Installer.
Contact your Installer.
ADEMCO 6160RF
Keypad/Transceiver
Whether these panic keys function and the type of panic
alarms they produce is determined by the control
panel's capability and programming. (Check with your
installer for the availability and type of alarm of these
panic keys.)
Special Function Keys - These are the four keys
located to the left of the numeric keys (see below). The
keys may be programmed by your installer for panic
alarms or other special functions such as single-button
arming (Check with your installer to see which options
are available with your system.)
Special function keys and function key pairs must be
held down for at least 2 seconds to activate an alarm.
A set of adhesive labels with typical panic symbols is
provided. Place the appropriate label in the indented
area on each key, so that the user can easily identify
each key's function.
SOUNDER
The built-in speaker has the following functions:
• Produces warning sounds during alarm and trouble
conditions, and also during entry/exit delay periods.
Provides acknowledgment tones when keys are
pressed, and confirmation
command entries.
OFF AWAY STAY
MAXIMUM TEST BYPASS
INSTANT CODE CHIME
0 #
READY
PANIC KEY PAIR
Corrective Action
K0904V1 2/06 Rev. B
tones for successful
PANIC
KEY
PAIR
6160RF-001-V1