Table of Contents
Advertisement
5. API for Acquiring/Changing Parameters of VN-E4 _
5.11. Access Restrictions
The APIs below are related to access restrictions. These are equivalent to the features on the Access Restrictions page of the WEB setting
page. Refer to the instruction manual for details on the Access Restrictions page.
Acquiring Deny/Allow Setting of Client Restrictions from VN-E4
Format
Example of Response
Interpretation
Allowed users
Setting Client Restriction to Deny/Allow for VN-E4
Format
Example
Example of Response
Interpretation
Allowed user
Acquiring IP Address Setting of Restricted Client from VN-E4
Format
Example
Example of Response
Interpretation
Example of Response 2
Example of Response 2
Allowed users
Setting IP Address of Restricted Client for VN-E4
Format
Example
Example of Response
Interpretation
/api/param?network.access_control(api).logic
network.access_control(api).logic=deny&200 OK
Acquire the deny/allow setting of client restrictions. Either deny or allow will be returned. This API acquires the
same details as the "Access Restriction" item of "Client Address" at the top of the Access Restrictions page.
admin, operator
/api/param?network.access_control(api).logic=data
/api/param?network.access_control(api).logic=deny
network.access_control(api).logic&200 OK
Change the deny/allow setting of client restrictions. Specify as deny or allow. Details set by this API are the same
as those set by the "Access Restriction" item of "Client Address" at the top of the Access Restrictions page.
admin
/api/param?network.access_control(api).host(Number)
When acquiring the first IP address
/api/param?network.access_control(api).host(1)
network.access_control(api).host(1)=10.0.0.100&200 OK
Acquire the IP address setting of the restricted client. Setting is possible up to 10 items. Specify a value
between 1 to 10 for the number. The following will be returned if subnet mask is specified at the same time.
network.access_control(api).host(1)=10.0.0.0/24&200 OK
The above example indicates that the range is set as between 10.0.0.0 to 10.0.0.255. There are also cases when
FQDN instead of IP address is set.
network.access_control(api).host(1)=somedivision.somecompany.com&200 OK
This API acquires the same details as the "IP Address" item of "Client Address" at the top of the Access
Restrictions page.
admin, operator
/api/param?network.access_control(api).host(Number)=data
When setting the first IP address
/api/param?network.access_control(api).host(1)=10.0.0.100
network.access_control(api).host(1)&200 OK
Change the IP address setting of client restriction. Setting is possible up to 10 items. Specify a value between 1
to 10 for the number. A range of IP address may be specified if the subnet mask is also specified. For example,
set as follows to specify a range between 10.0.0.0 to 10.0.0.255.
5.11. Access Restrictions
53
Advertisement
Table of Contents
