Pioneer XW-NAV1K-K Operating Instructions Manual page 37

Additional information
Problem
Folder or file names are not
displayed in alphabetical
order.
Much time is required to
recognized the USB
device.
Power is not supplied to
the USB device.
Audio CD tracks cannot be
recorded on a USB device.
When connected to an HDMI-compatible device
Problem
Picture is not displayed.
Sound is not produced or
is distorted.
Multichannel audio signals
are not output.
Colors are not properly
displayed on TV screen.
Check
This is not a problem with this
unit.
What is the USB devices capacity? Some time may be required to load the data when large
Is Err displayed on the front panel
display? No power is supplied if
the power consumption is too
high.
Is there enough free space on the
USB device?
Are there 300 or more folders on
the USB device?
Are there already 99 PIONEER
folders on the USB device?
Check
Is the resolution properly set?
Is the HDMI cable properly
connected?
Is HDMI Out properly set?
Is HDMI Out properly set?
Is HDMI Color properly set?
Remedy
The order of the folder and file names displayed on the Disc
Navigator depends on the order in which the folders or files
were recorded on the USB device.
capacity USB devices are connected (this could take several
minutes).
Turn the power off then back on.
Turn the power off, then disconnect and reconnect the USB
device.
Press FUNCTION to switch to the other mode, then switch
again to the USB mode. (When the input is switched back to
USB, ' ' is displayed on the front panel display.)
If the USB device is equipped with an AC adapter, use the USB
device with the AC adapter connected.
Recording is not possible if there is not enough free space left
on the USB device. In this case, Available USB space is low
is displayed.
Recording is not possible if the USB device contains 300 or
more folders.
Recording is not possible if there are already 99 PIONEER
folders on the USB device.
Remedy
Set HDMI Resolution properly for the connected device
(page 26).
Restore HDMI Resolution to the default setting (720x480p/
720x576p) (page 27).
Connect the cable securely (all the way in).
With some cables, 1080p video signals will not be output.
Set HDMI Out to LPCM (2CH) or Auto (page 26).
Set HDMI Out to Auto (page 26).
Change the HDMI Color setting (page 26).
13
37
En