JVC KY-F560U - 3-ccd Color Camera Instruction Manual page 11

Part Names and Functions (continued)
5
[INCOM MIC] Intercom Mic [CARBON/
DYNAMIC] Switch
Use for selecting the type of intercom
headset microphone to be used.
[CARBON] : Choose this setting if car-
bon type microphone is to
be used.
[DYNAMIC] : Choose this setting if dy-
namic type microphone is
to be used.
If JVC Headset KA-310U is to be used,
choose the [CARBON] setting.
6
[CALL] Call Button
Press this button to send call signal to the
remote control unit operator if intercom
headset is not in-use.
When this button is pressed and held
down, call signal is being sent to the re-
mote control unit and its [TALLY] button
indicator will blink. Once the [CALL] but-
ton is released, call signal will not be sent
and the [TALLY] button indicator of the re-
mote control unit will go off.
7
[CALL] Indicator
If the remote control unit is connected, it
will light up during the duration when
[CALL] button is being pressed and held
down. The indicator will go off once the
[CALL] button is released.
8
Camera Mounting Frame
Remove this frame for the mounting of KY-
F560 camera.
9
Relay Board
This board is meant for connecting to KY-
F560 camera. This is to be inserted into
the slot at the rear of KY-F560.
0
[SDI OUT] SDI Output Terminal...Only
for KA-F5603U
Camera video is output in the form of SDI
signal.
Caution
To avoid causing malfunction, please do
not touch this terminal except when con-
necting cable to it.
!
[VF] Viewfinder Terminal (6 Pin)
Use for connecting cable from the View-
finder.
@
Viewfinder Holder
Use for mounting the VF-P400 4-inch
Viewfinder.
#
Lens Cable Clamp
This clamp is meant for securing the lens
cable.
6
11