Door Height Adjustment; Replace Base Grille - Viking DDSF136DSS Installation Manual

Installation Instructions
3. Adjust the rear leveling bolt to bring the refrigerator level with the side cabinets or cabinet end
panels.
4. If you want, you may now use the four leveling bolts to raise the refrigerator to reduce the gap
between the refrigerator top hinge and the cabinet opening. Check that all four leveling legs still touch
the floor and that the cabinet doors above the refrigerator open all the way.

Replace Base Grille

1. Open the refrigerator doors to 90°.
2. Replace the base grille. Place the lower clips into the bottom of the refrigerator and roll the grille up
until it snaps into place.

Door Height Adjustment

5
TOOLS NEEDED: ⁄ " or adjustable wrench.
16
IMPORTANT: Models are preset with a quarter's-thickness difference in door height and may not need
adjusting. If necessary after the refrigerator is loaded with food, follow the steps below to adjust the
door height up or down.
1. Locate the height adjustment bolt on the bottom hinge of the refrigerator door.
NOTE: For easier access to the height adjustment bolt, the refrigerator door should be closed.
2. Turn the height adjustment bolt using the
•
To raise the height, turn the bolt to the right.
•
To lower the height, turn the bolt to the left.
3. Check to make sure the doors are even at the top and bottom. If necessary, continue to turn the
height adjustment bolt.
5 ⁄ " or adjustable wrench.
16
14