Yamaha SWR2310-10G Owner's Manual page 31

3.
To the connector, connect a fiber optic cable
that is suitable for each module.
Removing an SFP module
Secure this unit so that it will not move, and while grasping the lever of the SFP module,
pull it slowly toward yourself to remove the module from the SFP/SFP+ port.
Supported SFP modules and SFP+ modules are collectively referred to here as SFP
modules.
1.
Detach the fiber optic cable.
2.
If the SFP module is connected to the upper
row of ports, lower the SFP module's lever.
If it is connected to the lower row of ports, raise the lever.
Caution
Do not look into the optical emitter when the SFP module is installed.
The SFP modules separately sold by Yamaha are class 1 laser devices. They may emit
laser beams invisible to the eye. If the laser beam enters your eye, your eyesight might be
damaged.
3.
Grasp the lever and pull out the SFP module.
Memo
Since this unit supports hot-swapping, an SFP module can be
removed without turning the power off.
SWR2310-28GT SWR2310-18GT SWR2310-10G
Connections
Connector
Fiber optic cable
Connector
Fiber optic cable
Lever
31