Aluminum Foil And Oven Liners; Replacing Interior Oven Light - Frigidaire DGEF3031KB - Gallery 30" Smoothtop Electric Range Use & Care Manual

Cooktop cleaning (cont'd)
DO NOT use the following on the cooktop:
• Do not use abrasive cleaners and scouring pads, such as
metal and some nylon pads. They may scratch the
cooktop, making it more difficult to clean.
• Do not use harsh cleaners, such as chlorine bleach,
ammonia or oven cleaners, as they may etch or discolor
the cooktop.
• Do not use dirty sponges, cloths or paper towels, as they
can leave soil or lint on the cooktop which can burn and
cause discoloration.

Aluminum foil and oven liners

WARNING
Protective liners—Do not use aluminum foil to line the
oven bottom. Only use aluminum foil as recommended
in this manual. Improper installation of these liners may
result in risk of electric shock, or fire.
Using a liner in the oven will restrict the heat and air flow
needed to obtain the best possible cooking results for any
oven, including the warmer drawer (some models).
Do not use oven bottom liners or use aluminum foil to cover
the oven bottom or any oven racks.
During self-clean the
oven temperature can
become hot enough to
melt aluminum cooking
utensils or aluminum
foil which could result in
damage to the oven
interior porcelain finish.
Aluminum foil and oven liners (cont'd)
Aluminum foil and the cooktop - Use of aluminum foil on
a hot cooktop can damage the ceramic glass. Do not use
thin aluminum cooking utensils or allow aluminum foil to
touch the ceramic cooktop under ANY circumstances.
Aluminum utensils and the cooktop - Care must be
taken when aluminum pots or pans are used on the
cooktop. If aluminum pans are allowed to boil dry when
using the cooktop, the utensil be damaged or destroyed,
and may fuse to, break or mark the ceramic glass
surface, permanently damaging the cooktop surface.

Replacing interior oven light

CAUTION
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection
against possible broken glass.
The interior oven light is
located at the rear of the
oven interior back wall and
is covered with a glass
shield held by a wire
holder.
The glass shield must
always be in place to
protect and shield the oven
interior light whenever
using the oven.
To replace the oven light bulb:
1. Turn electrical power off at the main source or unplug
the range.
2. While holding the glass shield in place, press wire
holder to one side to release the glass shield.
3. Remove glass shield. Replace bulb with a new 40 watt
appliance bulb.
4. Replace glass shield over bulb and snap wire holder
into place.
5. Turn power back on again at the main source (or plug
the range back in).
6. The clock will then need to be reset. To reset, see
Setting the Clock and Minute Timer in this Use &
Care Manual.
CARE & CLEANING
glass
shield
wire
holder
27