All components and parts of the Oven Door assembly can be serviced or replaced. The door is not
available as a complete assembly.
To service the door begin by removing the door
from the range. Open the door fully and pull both
hinge locks down until they stop. (Photo A & B)
Gently close the door until it stops against the hinge
locks at approximately a 45 degree angle. (Photo C)
Make sure you have a firm grasp on the door and
continue closing the door to disengage the hinges
from the receivers. (Photo D)
When the door is about 4 inches away from being
completely closed it can be lifted off the range.
(Photo E)
To reinstall the door reverse the previous steps. Use
your knee to stabilize and help guide the hinge arms
into the receiver slots in the frame. Once the door is
secure in the frame open it fully and close the hinge
locks back in to their normal position.
OVEN DOOR
Door Removal
Page 31
Photo A
Photo B
Photo C
Photo D
Photo E