Viking DBCV3082 Installation Instructions

VIKING MODEL VSIL10 IN-LINE FAN
SILENCER
ONLY FOR USE WITH VIKING 10" DUCT SYSTEMS
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
1. The VSIL10 is intended for residen-
tial use only.
2. Installation work must be done by qual-
ified person(s) in accordance with all
applicable codes and standards. This
inculdes fire rated contruction codes
and standards.
PLANNING THE INSTALLATION
1. The VSIL10 is designed to be installed as
part of a 10" duct system.
2. The VSIL10 may be used to reduce the
perceived ventilation sound level at the
range hood. For this particular application
the VSIL10 should be located between the
fan inlet and the range hood. For optimal
performance, locate the VSIL10 as close to
the inlet of the fan as possible. The VSIL10
may be mounted at any angle, horizontally
or vertically.
INSTALLING THE VSIL10
1. The VSIL10 is a non-directional device.
The airflow through the VSIL10 can be
in either direction.
2. The VSIL10 must be adequately supported by The VSIL10 must be adequately The VSIL10 must be adequately supported by
using hanging straps or framing.
3. Insert the ends of the VSIL10 into the 10"
duct system.
3. When cutting or drilling into wall or
ceiling, take care not to damage elec-
trical wiring or other hidden utilites.
4. When handling the duct silencer,
wear hand protection and stay clear
of sharp edges.
3. The VSIL10 may also be used to re-
duce perceived ventilation sound level
at the roof cap or wall cap. For this
application the VSIL10 should be
located between the fan outlet and
the roof cap or wall cap. To achieve
the best results locate the VSIL10
as close to the outlet of the fan as
possible. Again the VSIL10 may be
mounted at any angle, horizontally or
vertically.
Item# 450512
Rev. Date: 061908
DIMENSIONS – DIMENSIONES
All dimensions in inches
Toutes les dimensions en pouces
Todas las dimensiones en pulgadas
�� ���
��
��