Specifications; Instructions For Putting Into Use - Chicago Electric 99857 Set Up And Operating Instructions Manual

SpEciFicAtionS

Electrical Requirements
Output Voltage
Charging Method
Status Indicators
Overload Protection
Additional Protection
unpAcKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
inStructionS For
putting into uSE
read the EntirE importAnt
SAFEty inFormAtion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
From AccidEntAl
opErAtion:
unplug the tool from its
electrical outlet and
disconnect from battery
before assembling or making
any adjustments to the tool.
SKU 99857
120 V~ / 60 Hz
12 VDC / 1.5 Amps
3-Stage trickle charge
Red, Yellow and
Green LED lights
On / Off trickle
charging with Thermal
Overload Protection
Short Circuit and
Polarity Protection
to prEVEnt
SEriouS injury
For technical questions, please call 1-800-444-3353.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
mounting
1. The Battery Charger must be mount-
ed near the battery in the engine
compartment of the vehicle.
2. Leave at least 2-½" clearance in front
of the Output Wires (12) Plug.
3. You can mount the Charger on the
vehicle engine compartment wall
near the battery, or you can mount it
on a bracket held in place by the bat-
tery.
Bracket B (6)
Bracket A (9)
Side View with Brackets
Front View with Brackets
4. For Engine Compartment Wall
mounting, mark and predrill wall us-
ing Bracket A (9) or Bracket B (6) as
a template. See Figure 1 above. Be
Page 8