Inspection, Maintenance, And Cleaning; Troubleshooting - Chicago Electric Power Systems 95596 Set Up And Operating Instructions Manual

INSpEcTION, mAINTENANcE,
ANd clEANINg
1. WARNINg! Always make sure
the power Switch of the Inverter
is in the "OFF" position and the
unit is disconnected from its
power source before perform-
ing inspection, maintenance, or
cleaning procedures.
2. Before each use,
general condition of the Inverter.
Check for misalignment or binding
of moving parts, cracked or broken
parts, damaged electrical wiring,
and any other condition that may
affect its safe operation. If abnor-
mal heat, noise, or vibration occurs,
have the problem corrected before
further use.
do not use damaged equipment.
3. To clean the exterior parts of the
Inverter, use only a clean, dry
cloth. do not clean the unit with
water or harsh cleaners.
4. This Inverter does not contain
any replaceable parts. It the unit
needs service, make sure to take it
to a qualified service technician.
5. Make sure to store the Inverter in a
clean, dry, safe location out of reach
of children and other unauthorized
people.
cAuTION! All maintenance,
6.
service, or repairs not mentioned
in this manual must only be
performed by a qualified service
technician.
SKU 95596 For technical questions, please call 1-800-444-3353
inspect the

TROuBlESHOOTINg

1. If the low battery alarm sounds,
this means the input voltage is
below the necessary 10.6 volts
dc. The battery needs recharging.
You should stop using the tool/ap-
pliance and then recharge the bat-
tery. If this is not done, the Inverter
will shut off automatically at around
10.0 volts DC.
2. If you are unsure if the Inverter
will have the proper amount of
current to run a tool/appliance,
use this rough guideline: Take
the power consumption of the load
in amps and multiply it by 120
(output voltage). The result will be
the approximate number of watts
needed to power the tool/appliance.
Example: Load is rated at 26
amps. 26 amps x 120 volts = 3120
watts needed. You can not use this
device with the Inverter.
3. If your television will not turn on,
it is important to keep in mind
some appliances (including many
televisions) may require two to
six times their wattage to turn on.
This Inverter will not work with such
devices.
4. If your audio system buzzes
while using this Inverter, it is be-
cause some sound systems can-
not filter out the modified sine
wave produced by the Inverter. A
possible solution is to use a sound
system that incorporates a higher
quality power supply.
5. This Inverter is designed to mini-
mize the interference with televi-
sion signals. However, especially
with weak television signals, some
PAGE 9