Epson 7850p - PowerLite XGA LCD Projector Product Support Bulletin page 32

EPSON
Date: 04/02/2004
PSB.2004.04.001
PSB #:
N/A
Reference:
Product(s): PowerLite 735c/7850p
Configuring the Projector Name in EasyMP Network Screen Settings
Subject:
This bulletin was created to provide additional information on how to correctly set the projector
name in the EasyMP Network Screen settings window.
Description of issue:
A user is configuring the EasyMP Network Screen settings on a PowerLite 735c or 7850p
projector with the remote control in either "Easy Connect Mode" (Ad-Hoc) or "Access Point
Mode" (Infrastructure). The user then clicks on the "Advanced" button, selects the "Projector
name" field and with the remote control enters a name "Conf Room" (example only) with a space
in between the two words. The user clicks OK twice to update the projector but when the EasyMP
Network screen reappears, the projector name field still shows the previous name.
Note:
The blank space character can be found immediately before the capital letter A as you
are toggling through the list of available characters on the remote control.
Reason:
The "Projector name" field does not support a blank space as a valid character. It will allow you
to enter it but when you return to the EasyMP Network screen, you will see the Projector name
has reverted to the previous name. This occurs in "Easy Connect Mode" (Ad-Hoc) or "Access
Point Mode" (Infrastructure). If you need to break the Projector name apart for clarity, use dash
"-" or underscore " _" to separate your characters.
Note:
You can enter a blank space as a valid character in the ESSID field. The following
sections provide a list of valid characters you can use for both of these fields.
"Projector name" valid characters:
Capital letters A-Z, small case a-z, 0-9, and special characters: ! # $ % & ' ( ) - . @ ^ _ { } ~
No spaces are allowed.
"ESSID" valid characters:
Capital letters A-Z, small case a-z, 0-9, and special characters: ! " # $ % & ' ( ) * + , - . / : ; < = > ?
@ ] \ [ ^ _ ` } | { ~ and blank spaces.
We highly recommend that you limit the number of special characters when entering a name.
Use a dash "-" or underscore "_" to separate your characters. Using special characters may
cause problems with the naming convention when entering a name in the Projector name or
ESSID name fields.
P S
RODUCT UPPORT
B
ULLETIN
Page 1 of 2
PSB.2004.04.001
Originator: TC
Authorization:
Total Pages: 2