Initialize Hard Drives - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual

2. Click Properties. This brings up the "System Properties" panel.
3. Click the Hardware tab.
4. Click the Device Manager... button.
5. Verify that no devices have either a yellow band (!) or question mark (?) symbol next to it.
(See following note for pointer to exceptions)
Yellow (!) means that there is a resource issue with the device.
Question (?) means that the device is unknown.
6. If no (!) or (?) symbols are reported then you are done. Go to step 9. Otherwise, do the next
step.
7. Double click on each of the devices with (!) or (?). Note the "Device Status" message. Or if
a printer is available, use the View, Print from the menu to get a report.
8. See table 5 to verify any errors detected in steps 6 and 7.
9. Verify if the installed drivers are digitally signed.
A. In the Device Manager, click on the device (e.g HP NETRAID 1M/2M) that want to
verify.
B. Right click on that device.
C. Click Properties option.
D. Click on Driver Tab
E. Locate the"Digital Signer:" If the driver of that device is digitally signed then it will
display "MS Windows 2000 Publisher" or "Microsoft Windows Hardware
Compatibility Publisher"
If the driver of the device is not digitally signed we recommend that you check the HP
Website http://www.hp.com/. for the latest driver package. If available, install the new driver.
10. Check the Event viewer to make sure that there are no errors in the log.
Click on Start | Programs | Administrative tools | Event viewer.
NOTE: A warning message with source "DHCP" and errors with sources "W3SVC" and
"SMTPSVC" may appear in the "System Log" of Event Viewer. These warning and
errors will go away after configure all IP addresses for all Ethernet adapters.
11. Exit event viewer.

Initialize Hard Drives

To start the disk administrator use the following procedure.