Attach Clients To Network; Domain Controller Setup - HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual

10. Open a command prompt window to verify the TCP/IP configuration. Enter the command:
ipconfig /all
You should get a display showing the configuration information you entered above.
11. Test the link by entering the following at the command prompt:
ping computername
Where computername is the server name. You should get four reply's from 100.100.100.1, if
you don't get this result then there is a link problem which must be fixed before going any
further.
12. Test the link by doing a ping to one of the clients attached to the server, for example:
ping 100.100.100.2
You should get four reply's from the client.

Attach Clients to Network

Follow normal procedure to patch the clients to the proper hub with the server.

Domain Controller Setup

The Small Business Server 2000 reference guide calls this process "Promoting the server to a
domain controller".
1. Click Start | Run and enter the command:
dcpromo
2. Click Next at the "Active Directory Installation Wizard".
3. Click Next at the "Domain Controller Type" to accept default "Domain Controller for a new
Domain" radio button enabled.
4. Click Next at the "Create Tree or Child Domain" to accept default "Create a new domain
tree" radio button enabled.
5. Click Next at the "Create or Join Forest" to accept default "Create a new forest of domain
trees" radio button enabled.
6. At the text box for "Full DNS name for new domain:" type in the assigned DNS name for
your server (for example: hostname.com).