Removing The Ink Ribbon And Paper - Sony UP-DR200 Operating Instructions Manual

Removing the Ink Ribbon and
Paper
When the following message appears on the LCD, the
paper or ink ribbon corresponding to the designated
number of sheets has been used up.
Proceed as follows to remove the ink ribbon and paper
roll, and then load a new ink ribbon and paper roll.
Note
The above message is set to appear before the ink ribbon
and paper roll are completely used up. Even if there is
some ink ribbon and paper remaining, be sure to load a
new ink ribbon and paper roll.
1
Remove the output tray.
2
Remove and empty the scrap receptacle.
Note
If the scrap receptacle becomes too full, scraps that
are cut off may be unable to eject. This may result
in malfunction. Be sure to empty the scrap
receptacle each time you replace the paper roll.
16
Loading the Paper Roll and Ink Ribbon
3
Press and lower the paper door lever, hold the paper
door at the center portion, and pull the door forward
until it locks into the open position.
4
Remove the paper roll.
5
Remove the paper core from the paper roll.
Note
The paper core is reusable. Do not throw it away.