Table of Contents
Advertisement
Error message
No Paper
No Paper for Manual
Feed
No Paper MP or Size
Mismatch
No Paper in Tray 1 or
Size Mismatch
No Paper in Tray 2 or
Size Mismatch
No Paper in Tray 3 or
Size Mismatch
Print Overrun
Service call error
Storage Full
The RAMDISK size is set to 0 MB. Increase the RAMDISK size. Or there is no space to store
jobs. Delete unnecessary macros or fonts.
Replace PF KitMP
Call your dealer or KONICA MINOLTA Customer Service for a replacement paper feeding
kit (paper pick up roller and separation plate) for the MP tray.
Replace PF Kit1
Call your dealer or KONICA MINOLTA Customer Service for a replacement paper feeding
kit (paper pick up roller and separation plate) for Tray 1.
Replace PF Kit2
Call your dealer or KONICA MINOLTA Customer Service for a replacement paper feeding
kit (paper pick up roller and separation plate) for Tray 2.
Replace PF Kit3
Call your dealer or KONICA MINOLTA Customer Service for a replacement paper feeding
kit (paper pick up roller and separation plate) for Tray 3.
Replace Fuser Unit
Call your dealer or KONICA MINOLTA Customer Service for a replacement fuser unit.
Replace Laser Unit
Call your dealer or KONICA MINOLTA Customer Service for a replacement laser unit.
Replace Toner
Toner Low
The paper tray may be out of paper or not properly installed. If it is empty, put a new stack
of paper in the paper tray and then press Go. If the problem is still unsolved, the paper
pick-up roller may be stained. Clean the paper pick-up roller. See Cleaning the paper
pick-up roller on page 106.
If there is paper in the paper tray, make sure it is straight. If the paper is curled, straighten
it before printing. Sometimes it is helpful to remove the paper, turn the stack over and
put it back in the paper tray.
Cut the amount of paper in the paper tray, and then try again.
Make sure you use paper that meets KONICA MINOLTA recommended paper
specifications. See About paper on page 6.
Load the same size paper that you selected in the current driver setting.
Press Go to print the remaining data in the printer memory. Cancel the print job if you
want to delete the remaining data in the printer memory. See Control panel buttons on
page 79.
If this does not clear the error, reduce the complexity of your document or cut the print
resolution.
Add more memory. See Installing extra memory on page 86.
Change the following settings in the supplied Windows
combination of these settings will vary depending on your document:
Graphics mode
TrueType mode
®
Use Printer TrueType
1
Choose the Basic tab, choose Manual in Print Settings, and then click Manual Settings....
Check the LED indication to identify the error. See Service call indications on page 77.
See Replacing the toner cartridge on page 90.
Buy a new toner cartridge and have it ready for when the Replace Toner status is
indicated.
Action
1
Fonts
Troubleshooting
®
driver and try again. The best
7
112
Advertisement
Table of Contents
