Special Parameters - Kyocera Ci1000 Technical Reference Manual

!R! Text 'A'; Cir 1; Exit;
Each of these commands prints the capital letter 'A' inside a circle. In the printout shown
above, the unit is centimeters. The reason that the letter 'A' is off center in the circle is
that the cursor is not located at the center of the circle, but at left corner of the letter 'A'.
The command
!R! TEXT 'a'; CIR 1; EXIT;
prints a lowercase a because the letter occurs inside a character string.
The sole exception to upper and lowercase usage in PRESCRIBE commands occurs with
the initializing !R! command. This command must always use an uppercase R. The print-
ing system will not enter the PRESCRIBE mode in response to !r!.
In this manual, PRESCRIBE commands are printed in upper-case for readability.
Outside of PRESCRIBE mode, the printing system always distinguishes between upper-
case and lowercase letters and prints exactly what is sent.

Special Parameters

Some PRESCRIBE commands use unquoted strings of characters as parameters. Exam-
ples for these are the FSET (change current font set by characteristic) command and the
CSET (change symbol set by symbol-set ID) command. (See Chapter 4 for a detailed
explanation of how these commands are used to select fonts.)
The FSET and CSET commands use parameters that closely resemble the command
parameters used for font control in Hewlett-Packard's printer control language. For
example, the PRESCRIBE command
FSET 0p12h12v0s0b6T;
selects the font whose characteristics most closely matches the following font parame-
ters:
• Monospaced font (0p)
• Character spacing of 12 characters/inch (12h)
• Character height of 12 points (12v)
• Upright style (0s)
• Medium weight (0b)
• LetterGothicBM12-Roman typeface (6T)
In Hewlett-Packard's PCL, the corresponding command would be
ESC(s0p12h12v0s0b6T
Command Parameters
1-13