Cannot Cut Paper; Rel Lever Is In Wrong Position - Canon 2163B002 User Manual

Cannot cut paper.

There are sheets left on the Ejection Guide .
There is a foreign object by the Output Tray ,
obstructing the Cutter Unit .
You are not using the printer under the recommended
environmental conditions for the paper.
You are using paper that is not compatible with
automatic cutting.
The Cutter Unit stops in the middle of cutting.
The Cutter Unit is not installed.
In other cases, the Cutter Unit may be damaged.

Rel lever is in wrong position.

The Release Lever is up.
Cause
Cause
Corrective Action
Remove the paper.
Remove the foreign object.
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper. For details
on the recommended environmental conditions for
paper, see "Types of Paper". (→P.169)
Cut the roll manually.
(→P.193)
Move the Carriage to the left, remove the paper, and
return the Carriage to the right. If the roll cannot be
cut using the Cutter Unit , cut the roll manually.
(→P.201)
(→P.217)
(→P.193)
Install the Cutter Unit .
(→P.705)
Contact your Canon dealer for assistance.
Corrective Action
Lower the Release Lever .
If the error occurs again, turn off the printer and wait
a while before restoring power.
Messages regarding paper
Error Message 775