General - Honeywell HPF24S8 Installation Manual

System Overview

1.7 General

The HPF24S may be used in a number of different applications. It may be used as a remotely-
mounted power supply and battery charger where it can provide up to four coded or noncoded,
synchronized or nonsynchronized NACs (Notification Appliance Circuits). Alternatively, output
#4 can be used as a door holder circuit which will provide a steady 24 VDC output until an alarm
condition or AC fail condition causes it to drop to 0 VDC following a 10 second delay. All four
outputs can also provide power.
Style Y NAC
Note: All NAC
or Door Holder
outputs can be
converted to Style
Output #4
Z with ZNAC-4
option module
AC Power
One possible application for the HPF24S remote power supply utilizes the NAC repeater feature.
In this application, one or two NACs are connected from the main FACP to the remote power
supply control input circuits. When the control input circuits are activated by the reverse polarity
of the NACs, the power supply will activate its corresponding output circuits as programmed by
SW1 DIP switch configuration (refer to Table 3.1 on page 21).
During the inactive state, the remote power supply supervises its NAC field wiring for short and
open conditions. If a fault is detected, the power supply will enter a trouble condition and
illuminate the NAC Trouble LED. When the NACs are activated, the supervision is disabled and
the circuits are no longer supervised. Supervision of other power supply faults such as low battery,
battery charger trouble, ground fault and AC loss will continue and may be monitored via the
power supply trouble relay.
If an application requires that all four outputs activate at the same time, only one NAC is required
from the FACP. For this application, the NAC is connected to control input circuit #1 and SW1
DIP switch is set for this operation.
14
Power
Style Y NAC
Style Y NAC
Output #2
Output #3
Input/Output Functions are Programmable by
SW1 DIP Switch Settings
Battery Charger
Figure 1.2 Simplified HPF24S Block Diagram
Style Y NAC HPF24S Trouble
Output #1 Contact Output
HPF24S Series Power Supplies — P/N 52751:D3 5/11/2010
General
24 VDC Specific
Application Power
NAC Control
Input #2
(from FACP)
NAC Control
Input #1
(from FACP)
Sync. Input