Switching Zones; Setting The Zone For Which The Sub Remote Control Unit Is Used (Zone Select Lock Mode); Setting The Remote; Resetting The Settings - Denon AVR-3808CI Owner's Manual

Multi-zone
indicator
[ZONE SELECT]
[ZONE OFF]
[ADVANCED SETUP]
[MENU]
[RANDOM] [USB]
[REPEAT] [ALL MUSIC/
FAVORITES]

Switching Zones

Use this procedure to select the zone to be operated by
the sub remote control unit.
1
[ZONE SELECT]
Press .
The currently selected multi-zone indicator lights.
2
While the multi-zone indicator is light, press
SELECT]
to select the zone to be operated.
The currently selected multi-zone indicator lights.

Setting the Zone for Which the Sub
Remote Control Unit is Used (ZONE
SELECT LOCK Mode)
We recommend always using the sub remote control unit
for the same room. When this is done, the unit can be
set so that the zone does not switch when buttons are
operated.
1
Use the tip of a pen to press
All the multi-zone indicators light.
2
Select the multi-zone to be set.
The selected multi-zone indicator lights.
q T o set to main zone : Press [REPEAT].
w T o set to ZONE2 : Press [RANDOM].
e T o set to ZONE3 : Press [USB].
3
Use the tip of a pen to press
The multi-zone indicator turns off.
To Cancel
1
Use the tip of a pen to press
The currently selected multi-zone indicator lights.
2
[ZONE SELECT].
Press
All the multi-zone indicators light.
3
Use the tip of a pen to press
The multi-zone indicator turns off.
[ZONE
Setting the Remote ID
When using multiple DENON AV receivers in the same
room, make this setting so that no AV receiver other than
the desired one operates.
1
While pressing
with the tip of a pen.
The multi-zone indicator corresponding to the currently selected
remote ID flashes.
[ADVANCED SETUP]
.
2
Select the remote ID to be set.
q T o set to 1 : Press [REPEAT].
The "M" indicator flashes.
w T o set to 2 : Press [RANDOM].
The "Z2" indicator flashes.
e T o set to 3 : Press [USB].
The "Z3" indicator flashes.
[ADVANCED SETUP]
.
r T o set to 4 : Press [ALL MUSIC/FAVORITES].
The "Z4" indicator flashes.
3
While pressing
with the tip of a pen.
[ADVANCED SETUP]
.
The multi-zone indicator turns off.
NOTE
When changing a setting, be sure to set the same remote ID as the
AVR-3808CI's (vpage 35).
[ADVANCED SETUP]
.

Resetting the Settings

While pressing
with the tip of a pen.
All the multi-zone indicators flash 4 times, then all the settings are
restored to their defaults.
[MENU] [ADVANCED SETUP]
, press
[MENU] [ADVANCED SETUP]
, press
[ZONE OFF] [ADVANCED SETUP]
, press