Stand Installation - LG 42PG60C - - 42" Plasma TV Owner's Manual

3 3 2 2 / / 3 3 7 7 / / 4 4 2 2 L L G G 5 5 * * * * * *
BACK COVER FOR WIRE
ARRANGEMENT
Connect the cables as necessary.
1
To connect additional equipment, see the
EXTERNAL EQUIPMENT SETUP section.
Secure the power cable with the PROTECTIVE
BRACKET/Screw or PLUG IN TYPE HOLDER
for power code. It will help prevent the power
cable from being removed by accident.
PROTECTIVE BRACKET
(This feature is not available for all models.)
Install the CABLE MANAGEMENT CLIP as shown.
2
If your TV has the CABLE HOLDER, install it as
shown and bundle the cables.
CABLE MANAGEMENT CLIP
CABLE HOLDER
Put the cables inside the CABLE MANAGEMENT
3
CLIP and snap it closed.
PROTECTION COVER
After removing the stand, install the included p p r r o o t t e e c c t t i i o o n n
c c o o v v e e r r over the hole for the stand.
Press the P P R R O O T T E E C C T T I I O O N N C C O O V V E E R R into the TV until you
hear it click.
or
PLUG IN TYPE HOLDER

STAND INSTALLATION

Carefully place the TV screen side down on a cush-
1
ioned surface to protect the screen from damage.
Assemble the parts of the S S T T A A N N D D B B O O D D Y Y
2
with C C O O V V E E R R B B A A S S E E of the TV.
Assemble the TV as shown.
3
4
x 4
Tighten the stand with the
four screws (provided as
parts of the TV).
or
Tighten the two of these four screws
x 2
x 2
and the two Torx plus star head screws
(provided as parts of the TV) to secure the TV. Tighten
the two Torx plus star head screws with a star head dri-
ver bit (not provided as parts of the TV).
! NOTE
When assembling the desk type stand, make sure
G G
the bolt is fully tightened (If not tightened fully,
the TV can tilt forward after the product installa-
tion). Do not over tighten.
With some TVs, the PLUG IN TYPE HOLDER
G G
and the CABLE HOLDER are included. If these
holders are inserted into the hole provided on
back of the TV, they cannot be removed.
S S T T A A N N D D B B O O D D Y Y
C C O O V V E E R R B B A A S S E E
15