Table of Contents
Advertisement
The oven lights are standard 40-watt appliance bulbs. They will
come on when the oven door is opened. They will not work
during the Self-Cleaning
cycle. When the oven door is closed,
press OVEN LIGHT to turn them on or off.
To Replace:
Before replacing, make sure the oven is off and cool.
1. Disconnect
power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise
to remove.
To Replace:
1. Insert both hanger arms into the door.
3. Turn bulb counterclockwise
to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Reconnect power.
For normal range use, it is not suggested to remove the oven
door. However, if necessary, follow these instructions.
The oven
door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3=
4.
Close the oven door as far as it will shut.
While holding the oven door on each side with both hands, lift
the oven door up.
Continue to push the oven door closed and pull it away from
the oven door frame.
2. Open the oven door.
You should hear a "click" as the door is set into place.
3. Move the hinge levers back to the locked position. Ensure
that the door is free to open and close. If not, repeat the
removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
•
Has a household fuse been blown or has the circuit
breaker been tripped?
Replace the fuse or reset the circuit.
•
Is the appliance wired properly?
See Installation Instructions.
Oven will not operate
•
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
•
Has a delay start been set?
See "Timed Cooking" section.
•
On some models, is the Control Lock set?
See "Control Lock" section.
•
On some models, is the Sabbath Mode set?
See "Sabbath Mode" section.
•
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning the other oven cannot be set
or turned on.
•
On double oven models, has the correct oven been
selected?
Choose UPPER OVEN or LOWER OVEN first.
Oven temperature too high or too low
•
Does the oven temperature
calibration need adjustment?
See "Oven Temperature Control" section.
Display shows messages
•
Is the display showing "PF", "PF id=27" or "PF id=30"?
There has been a power failure. Clear the display. See
"Display(s)" section. On some models, reset the clock, if
needed. See "Clock" section.
•
Is the display showing a letter followed
by a number?
Clear the display. See "Display(s)" section. If it reappears, call
for service. See "Assistance
or Service" section.
14
Advertisement
Table of Contents
