Alamo Industrial Machete 2 02986941C Operator's Manual page 91

Never allow children or other persons to ride on the Tractor or Implement.
Falling off can result in serious injury or death.
Before transporting tractor between locations, idle
the tractor engine, disengage the attached head,
and wait for all head motion to come to a complete
stop. Place the boom in its storage cradle rest
support and then turn the joystick master switch to
the OFF position.
• Placing Boom Articulating Arm on Boom Arm
Rest
• Extend the dipper section approximately half
way out.
• Bring the Lift to its full height and carefully
swing the boom back until it is just positioned
over the Boom Rest. NOTE: There is a formed
"V" plate on the dipper section that fits onto the
boom arm rest.
• Lower the Lift until this "V" rest on the Boom
Rest (this may take come re-adjustment of the
dipper section).
• Place the Master Switch in to the OFF position.
The boom is now in the transport position. To
remove the boom from the Boom Rest, pull the Lift
back and raise the boom about 6 inches. Then
Swing the boom around to the desired position.
OPS-B- 0013_A
MACHETE 2 11/08
©2008 Alamo Group Inc.
OPERATION
Operation Section 3-43
(SG-10)