Epson C850071 - RIP Station 5000 User Manual page 52

Page 52
—If your TCP/IP network has a gateway, and users outside the gateway print to
Gateway
the RIP Station using TCP/IP, enter the gateway address here. Obtain the correct gateway
address from your network administrator.
Protocol Setup (AppleTalk)
—Select to enable Apple Talk if you have an AppleTalk network con-
Enable AppleTalk
nected to the RIP Station. This setting enables the RIP Station to communicate over
AppleTalk networks.
—The RIP Station searches the network for AppleTalk zones in your network
Select Zone
segment. Scroll through the list to select the AppleTalk zone in which you want the
RIP Station to appear. If your segment has only one zone, the RIP Station is assigned to
that zone automatically.
If no AppleTalk zone can be found, your network may have no defined zones, or else the
network cable has not been connected (see Chapter 4 in the Administrator Guide).
Protocol Setup (IPX Frames)
—Click the Select Frames button to specify IPX frames used with NetWare.
Select Frames
See your network administrator to verify which frame type to choose.
In the IPX Frames dialog box, select frames and use the Add and Remove buttons to specify
the selected frames, then click OK.