Network Setup - Epson C850071 - RIP Station 5000 User Manual

Network Setup

You can modify most of the Network Setup options— including Port Setup, Protocol
Setup, PServer Setup, and Service Setup— from Fiery WebSetup.
T P S
O CONFIGURE ORT ETUP
• Click the Port Setup tab in the Network Setup dialog box.
You can then adjust settings as detailed in the following sections.
Port Setup (Ethernet)
Enable Ethernet
Transmission Speed
the speed ( 10 Mbps or 100 Mbps ) of the network to which the RIP Station is attached.
The options 10 Mbps TP and 10 Mbps AUI refer to how the Ethernet cable is connected,
either through twisted pair cable or the AUI.
Port Setup (Parallel Port)
Enable Parallel Port
a single Windows computer to the parallel port and print directly to the RIP Station.
Enabling the parallel port does not conflict with using Ethernet communication with
N :
OTE
the RIP Station.
Ignore EOF Character
that the RIP Station should ignore end-of-file (EOF) messages. Check this box to print
PostScript files in binary format (not ASCII); under normal circumstances, the box should
not be checked. When this option is selected, the RIP Station uses the parallel port timeout
value to determine when the end of the file has been reached.
Parallel Port Timeout (seconds)
ting determines how long the RIP Station waits without receiving data from the parallel
port before deciding that the current job is complete. Until the timeout, the RIP Station
cannot receive new jobs through the parallel port, but it can continue to receive network
print jobs.
:
—Select if the RIP Station is to be connected to an Ethernet network.
—Select Auto Detect if your network environment is mixed, or select
—Select if you want to print through the parallel port. You can connect
—Available only if Enable Parallel Port is selected, this option specifies
—Available only if Enable Parallel Port is selected, this set-
Page 50