Table of Contents
Advertisement
Alamo Industrial mowers use balanced and matched system components for blade carriers, blades,
cuttershafts, knives, knife hangers, rollers, drivetrain components, and bearings. These parts are made and
tested to Alamo Industrial specifications.
specifications. The use of "will fit" parts may reduce mower performance, void mower warranties, and present
a safety hazard. Use genuine Alamo Industrial mower parts for economy and safety.
Transporting Safety Instructions and Practices
Be particularly careful when transporting the Implement with the Tractor. Turn curves or go
up hills only at a low speed and using a gradual steering angle. Rear mounted implements
move the center of gravity to the rear and remove weight from the front wheels.
certain, by adding front ballast, that at least 20% of the tractor's weight is on the front wheels to prevent rearing
up, loss of steering control or Tractor tip-over. Slow down on rough or uneven surfaces to prevent loss of
steering control which could result in property damage or possible injury. Do not transport unless 3-Point lift
lever is fully raised and in the latched transport position. Dropping implement in transport can cause serious
damage to the tractor and/or Implement and possibly cause the operator or others to be injured or killed.
Allow sufficient clearance for the Implement to swing outward while turning. Implements
carried behind the Tractor will swing outside the tire path when making turns. Contacting a
solid object while turning will cause equipment damage and possible injury.
Be particularly careful in transport. The Mower has raised the center of
gravity for the tractor and has increased the possibility of overturn.
Turn curves or go up slopes only at low speed and using a gradual
turning angle. Slow down on rough or uneven surfaces.
When transporting Boom Mower on a truck or trailer, the height or width
may exceed legal limits when the boom is in the transport position.
Contact with side or overhead structures or power lines can cause
property damage or serious injury or death. If necessary lower boom to
reduce height and/or remove mowing head to reduce width to the legal
limits.
(SBM-8)
Never operate the Tractor and Mower Unit without an OPS (Operators
Protective Structure) or Cab to prevent injury from objects thrown from
ground or from overhead trimming.
passersby are with in 100 yards.
The Joystick Master Control Switch must be OFF to prevent accidental movement of the
boom and cutting head whenever the mower is not being operated.
SAMURAI 12/08
©2008 Alamo Group Inc.
SAFETY
PARTS INFORMATION
Non-genuine "will fit" parts do not consistently meet these
SEE YOUR ALAMO DEALER
(SBM-3)
Stop mowing if workers or
(SBM-9)
Safety Section 1-14
(SPRM-1)
Make
(S3PT-2)
(S3PT-20)
(SBM-16)
Advertisement
Table of Contents
