Lexmark 25C0010 - X 500n Color Laser Manual page 89

Card stock and label guidelines
When printing on labels:
•
Set the Paper Type to Labels from the printer driver.
•
Use standard-size products (either A4 or Letter).
•
Do not use label sheets with a slick backing material.
•
Do not print within 1 mm (0.040 in.) of the die-cut.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam. Partial
sheets will also contaminate your printer and your cartridge with adhesive, and could void your printer and
cartridge warranties.
•
Use labels that can withstand temperatures of 180°C (356°F) without sealing, excessive curling, wrinkling, or
releasing hazardous emissions.
•
Verify that your label adhesive material can tolerate a fusing temperature of 180°C (356°F) for 0.1 second.
•
Use labels that can withstand pressure of 25 pounds per square inch (psi).
•
Do not print within 1 mm (0.040 in.) of the edge of the label, of the perforations, or between die-cuts of the label.
•
Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.040 in.) away from edges. Adhesive material will contaminate your printer and could void your
warranty.
•
If zone coating of the adhesive is not possible, a 3-mm (0.125-in.) strip should be removed on the leading and
driver edge, and a non-oozing adhesive should be used.
•
Remove a 3-mm (0.125-in.) strip from the leading edge to prevent labels from peeling inside the printer.
•
Portrait orientation is preferred, especially when printing bar codes.
•
Do not use labels that have exposed adhesive.
•
Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or otherwise damaged.
•
Do not load a sheet of labels through the machine more than once.
•
Load labels into the manual bypass feeder with the recommended print side faceup and the top edge going in
first.
When printing on card stock:
•
Set the Paper Type to Card Stock from the printer driver.
•
Do not use preprinted card stock manufactured with chemicals that may contaminate the printer. Preprinting
introduces semi-liquid and volatile components into the printer.
•
Do not use card stock that is creased. It may cause paper jams.
•
We recommend the use of grain short card stock.
•
Load card stock into the manual bypass feeder with the recommended print side faceup and the top edge going
in first.
Printer specifications
89