Power System Checkout; Checking The Ac Adapter; Checking Operational Charging - Lenovo 418734U - IdeaPad S9e 4187 Hardware Maintenance Manual

Power system checkout

To verify a symptom, do the following:
1. Turn off the computer.
2. Remove the battery pack.
3. Connect the ac adapter.
4. Check that power is supplied when you turn on the computer.
5. Turn off the computer.
6. Disconnect the ac adapter and install the charged battery pack.
7. Check that the battery pack supplies power when you turn on the computer.
If you suspect a power problem, see the appropriate one of the following power
supply checkouts:
v "Checking the ac adapter"
v "Checking operational charging"
v "Checking the battery pack" on page 30
v "Checking the backup battery" on page 30

Checking the ac adapter

You are here because the computer fails only when the ac adapter is used.
v If the power-on indicator does not turn on, check the power cord of the ac
v If the computer does not charge during operation, go to "Checking operational
To check the ac adapter, do the following:
1. Unplug the ac adapter cable from the computer.
2. Measure the output voltage at the plug of the ac adapter cable. See the
3. If the voltage is not correct, replace the ac adapter.
4. If the voltage is acceptable, do the following:
Note: Noise from the ac adapter does not always indicate a defect.

Checking operational charging

To check whether the battery charges properly during operation, use a discharged
battery pack or a battery pack that has less than 50% of the total power remaining
when installed in the computer.
adapter for correct continuity and installation.
charging"
following figure:
2
(20V)
v Replace the system board.
v If the problem persists, go to "IdeaPad S9e, S10e, and S10" on page 45.
Pin Voltage (V dc)
1 +20
2 Ground
1
29
General checkout