Memory Upgrade Module; Removing Memory Modules - Fujitsu M2010 - Mini-Notebook - Atom 1.6 GHz How To Use Manual

Memory Upgrade Module

Your Fujitsu M2010 notebook comes with 1GB of high speed Double Data Rate Synchronous Dynamic
RAM 2 (DDR2 SDRAM), 533 MHz factory installed. To increase your system's memory capacity, you may
remove the original module and replace it with a memory upgrade module. To ensure 100% compatibility,
purchase the SDRAM module only from the Fujitsu web store at www.shopfujitsu.com.

Removing Memory Modules

1
Turn off power to your notebook and remove any power adapter (AC or auto/airline).
2
Make sure that all the connector covers are closed.
3
Turn the system bottom side up, and remove the screws of the memory upgrade module compartment.
(Figure 13).
4
Remove the cover.
5
Pull the clips sideways away from each side of the memory upgrade module at the same time. (Figure 13)
6
While holding the clips out, remove the module from the slot by lifting it up and pulling towards the rear of your
notebook.
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
.
UPGRADE MODULE
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
(ESD). T
O MINIMIZE RISK TO THE MODULE
•
B
EFORE HANDLING A MEMORY MODULE
STATIC ELECTRICITY BUILT UP IN YOUR BODY
•
W
HEN INSTALLING OR REMOVING A MEMORY MODULE
TOUCH ANY CONTACTS OR CHIPS
TERMINALS OR COMPONENTS
.
COMPONENTS
•
B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
E
VEN IF THE SYSTEM IS IN HIBERNATE OR SLEEP STATES
COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
56 - Memory Upgrade Module
,
OBSERVE THE FOLLOWING PRECAUTIONS
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE
.
,
HOLD IT BY THE EDGE SO AS NOT TO
. B
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE
,
DATA COULD BE LOST OR THE MEMORY
:
.
.