Commercial Quality Vacuum Sealer
MAGIC VAC™ LOSES VACUUM AFTER BEING SEALED
Leaks along the seal can be caused by wrinkles, crumbs, grease or
liquids. Reopen bag, wipe the top inside of the bag and smooth it
out along the sealing strip before resealing.
The release of natural gases or fermentation from foods (such as
fresh fruits and vegetables) may occur. Open bag if you think food
has begun to spoil and discard food. Lack of refrigeration or fluctu-
ating temperatures in the refrigerator can cause food to spoil. If
food is not spoiled, consume food immediately.
Check the bag for a puncture or hole which may have released the
vacuum. Cushion sharp edges in the contents of the bag with paper
MAGIC VAC™ NOT SEALING BAG PROPERLY
Should Sealing Bar overheat and melt the bag, it may be necessary
to lift the Lid and allow the Seal Bar to cool for a few minutes.
Built-in safety shut-off may shut the machine off if it becomes
overheated. Allow Magic Vac™ to cool down for 15 minutes and
MAGIC VAC™ DOES NOT DRAW VACUUM IN CONTAINERS
Ensure the Accessory Hose is secured on both ends.
Leave adequate head space at the top of the jar or canister.
Make sure arrow on canister lid knob points to Vacuum setting.
Use the correct size Jar Attachment. Large size is used with wide-
mouth canning jars. Small size is used with narrow mouth jars.
Check Jar Attachment to make sure it is not worn or damaged.
If liquids bubble up when vacuum packing, remember they must
be cooled prior to vacuum packing. Cool liquids rapidly under
refrigeration and not at room temperature.
MAGIC VAC™ CANISTERS AND CONTAINERS LOSE THEIR VACUUM
Make sure arrow on the knob of canister lid and universal lid is
turned to the closed position after vacuuming.
Examine jar or canister rims and lids for defects in the sealing
areas. Clean rim and lid with damp cloth and vacuum again.
Check that canister lid and universal lid gasket are in place and
are not damaged.
Check that the O-rings under canister lid and universal lid are in
place and completely seated.
Canning jar lids must be perfect and not bent.
Canning jar lid may need to be replaced with a new one.
Storing your Deni Magic Vac™
Keep your unit on your counter or hang it on the
wall. To mount it on the wall, insert two screws
into the wall the same distance apart as the
holes on the back of the unit. Be sure the screws
are sturdy enough to hold the weight of the unit.
Place the holes on the back of the unit over the
screws and hang unit. You will be surprised how often you use it. This
is an appliance that will be used every day to keep your foods fresh-