Table of Contents
Advertisement
Troubleshooting
Troubleshooting
Solving basic problems
Solving basic printer problems
If there are basic printer problems, or the printer is unresponsive, make sure:
•
The power cord is plugged into the printer and a properly grounded electrical outlet.
•
The electrical outlet is not turned off by any switch or breaker.
•
The printer is not plugged into any surge protectors, uninterrupted power supplies, or extension cords.
•
Other electronic equipment plugged into the outlet is working.
•
The printer is turned on. Check the printer power switch.
•
The printer cable is securely attached to the printer and the host computer, print server, option, or other network
device.
•
All options are properly installed.
•
The printer driver settings are correct.
Once you have checked each of these possibilities, turn the printer off, wait for about 10 seconds, and then turn the
printer back on. This often fixes the problem.
Printer control panel display is blank or displays only diamonds
The printer self test failed. Turn the printer off, wait about 10 seconds, and then turn the printer back on.
If the clock graphic and Ready do not appear, then turn the printer off and contact Customer Support.
Embedded Web Server does not open
These are possible solutions. Try one or more of the following:
C
HECK THE NETWORK CONNECTIONS
Make sure the printer and computer are turned on and connected to the same network.
C
HECK THE NETWORK SETTINGS
Depending on the network settings, you may need to type https:// instead of http:// before the printer IP
address to access the Embedded Web Server. For more information, see your system administrator.
219
Advertisement
Table of Contents
