NEC LCD2690WUXI2-BK - MultiSync - 26" LCD Monitor User Manual page 26

TagA Tile Matrix
TagB Date & Time
TagC Schedule
TagD ECO Mode Information Displays the estimated power saving information in watt-hours.
TagE Information
The Tile Matrix feature allows one image to be displayed over multiple screens. This
feature can be used with up to 25 monitors (5 vertical and 5 horizontal). Using Tile Matrix
requires the PC output signal be sent through a distribution amplifier to each individual
monitor.
H MONITOR: Select the number of horizontal displays.
V MONITOR: Select the number of vertical displays.
MONITOR No: Select a position to expand the screen.
TILE COMP: Works in tandem with Tile Matrix to compensate for the width of the tile
bezels in order to accurately display the image.
Tile Comp with 4 monitors (black area shows monitor frames):
monitor1 monitor2
monitor3 monitor4
Tile Comp OFF
Sets the current date and time for internal clock. Date and Time must be set in order for
the SCHEDULE function to work.
Daylight Saving: For those time zones where Daylight Saving Time (Summertime)
is observed.
Programs the monitor's working schedule. Schedule the power on and power off with hour
and a day of the week. Also sets the input port. This OSD can't remove except EXIT.
Using the "SCHEDULE" function allows you to set up to seven different scheduled time
intervals when the LCD Monitor will be activated.
You can select the time the monitor turns on and turns off, the day of week the monitor is
activated, and which input source the monitor will use for each scheduled activation
period. A check mark in the box next to the number of the schedule indicates that the
selected schedule is in effect.
To select which schedule to set, use the up/down arrows to move the cursor vertically
under the number (1 to 7) of the schedule.
Use the "Down" or "Up" buttons to move the cursor horizontally within the particular
schedule. The "SELECT" button is used to make a selection.
If you create a schedule but do not want to use a power on time, select "--" in the "ON"
time slot.
If you do not want to use a power off time select "--" in the OFF time slot.
If there is no input selected ("-----" showing in the input spot) the input from the previous
schedule will be used.
The selection of EVERY DAY within a schedule takes priority over other schedules that are
set up to operate weekly.
Schedules are numbered 1-7. If two schedules are programmed for the same time, then
the highest numbered schedule has priority. For example schedule #7 will take priority
over schedule #5.
When schedules are overlapping, scheduled Power ON time has priority over scheduled
Power OFF time.
When the "OFF TIMER" is set, the "SCHEDULE" function is disabled.
Before powering off, a message will appear on the screen asking the user if they want to
delay the turn off time by 60 minutes. Press any OSD button to delay the turn off time.
Provides information about the current display resolution Technical data, including the
preset timing currently being used and the horizontal and vertical frequencies is also
displayed.
English-24
monitor1 monitor2
monitor3 monitor4
Tile Comp ON