Mammoth BioShield18 Manual

ELECTRICAL INPUT: 24V DC 50/60Hz 1A
WARNING: AVOID EXPOSING UNPROTECTED
BioShield18
EYES AND BARE SKIN TO UV-C
Ultraviolet Treatment Systems
REPLACE LAMP ANNUALLY OR AS ADVISED
To order replacement lamp: www.BioShieldUV.com
STEP 1: STEP 1: STEP 2: STEP 3:
OR
Use a 2-1/4" drill to Make a starting hole and Test fit the device to Use sheet metal screws
create two openings then use a metal shear to ensure proper fit for flush provided to secure the UV air
create two openings mount sanitizer
INSTALLATION TEMPLATE
Place this label on
desired location
for installation
Caution
For 2-1/4 Drill Bit For 2-1/4 Drill Bit
Cut hole only in ductwork
to prevent accidental
cutting of wires or
refrigerant pipes