Download  Print this page

HP 201723-B21 - StorageWorks Modular SAN Array 1000 Hard Drive Release Note page 6

Storageworks simple san
Hide thumbs
   

Advertisement

Windows Server 2008 upgrade issue: Performing an upgrade from a previous installation on the
Windows Server 2008 will cause MSA2000 MPIO and SES drivers to fail to install.
Workaround: These components are not required by the Windows Server 2008. You can ignore
the failure of those components during an upgrade from a previous version.
EVA-specific issues
EVA configuration: The SSCM has the following restrictions when managing an EVA array:
• Host definitions cannot be removed from the EVA by the SSCM.
• After a port (HBA) has been added to a host definition, the port cannot be removed by the
SSCM.
• HP Command View EVA offers great flexibility in how you can configure an EVA. However,
the SSCM may not operate as expected if an array was configured using HP Command View
EVA. You can use SSCM or HP Command View EVA to configure an array, but not both.
NOTE:
Using HP Command View EVA to delete unwanted entries in an array's configuration (such as a
host or port that has been physically removed) is supported.
EVA login account: If the EVA login user name is changed, use the HP VDS Configuration Utility
for EVA to re-enter the new user name and password. This utility is installed with the EVA VDS
hardware provider and can be launched from Start > Programs > Hewlett-Packard > Hardware
Providers.
EVA4400 not discovered on startup: The EVA4400 is not discovered upon startup of SSCM.
Workaround: If your SAN contains an EVA4400, ensure that all HP Command View EVA
nl
installations in the SAN are running HP Command View EVA 8.0 or later.
MSA1x00-specific issues
MSA LUN name between Array Configuration Utility (ACU) and SSCM does not match: LUN names
created by the MSA ACU and the SSCM do not match when displayed. The ACU LUN name is
partly shown in SSCM as LUN identification.
MSA hardware provider memory leak: The HP MSA hardware provider installed with the HP
StorageWorks SSCM has a memory leak that may increase over time when VDS operations are
exercised. To reclaim lost memory, close SSCM to unload the MSA hardware provider. See the
HP website for updates to the HP MSA hardware provider.
Hosts connecting to MSA storage subsystems may not be discovered by SSCM during fabric changes:
When MSA responds to a fabric event, such as zoning changes, the HBA agent software takes
some time to discover the MSA storage subsystem. When the system is in this state, and SSCM is
launched, it may not discover the host because its HBA agent software is still busy.
Workaround: If this occurs, either relaunch SSCM after a few minutes or refresh the server list,
and/or manually add the server.
Switch issues
SSCM and switch passwords: If the switch password is set up or updated using SSCM, SSCM
nl
remembers the password and will not prompt for one whenever a switch operation is initiated.
However, if you set up or change the password in another application (such as QuickTools), SSCM
6

Advertisement

loading

  Related Manuals for HP 201723-B21 - HP StorageWorks Modular SAN Array 1000 Hard Drive

This manual is also suitable for:

353803-b22 - storageworks modular smart array 1000 san starterConnection manager 2.10