Getting Started (Required Initial Setup); Installing Two "Aa" Batteries; Initial Signal Connections Integrated Digital (Dtv) / Analog (Rf) Antenna Connection - Sanyo DP26647 Owner's Manual

GETTING STARTED (REQUIRED INITIAL SETUP)

1
Install batteries in remote control (2AA, not included).
PRECAUTIONS
To ensure safe operation, please observe the following
precautions:
Replace both batteries at the same time. Do not use a new
battery with a used battery.
Risk of explosion, if battery is replaced by an incorrect type
or installed incorrectly.
Do not expose the Remote Control Unit to moisture or
heat.
2
Connect Signal to the DTV's Integrated Analog / Digital
75 ohm Antenna Input terminal.
CABLE BOX OR SATELLITE BOX
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note:You must search for ClearQAM channels using
the "Digital Cable Search" menu option.
RF ANTENNA
OR
CABLE
OR
DTV RIGHT SIDE (VIEWED FROM BACK)
OR
3. The output from an external device such as; a VCR
or cable box.
Signals from a Set-top (STB) Box should be received
through the Video 1, 2, or 3, or HDMI Input 1 or 2 jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
(CONTINUED ON NEXT PAGE.)
Match the "+" and "–"
signs on the batteries with
marks inside the remote
control.
ANALOG / DIGITAL
ANTENNA IN
14