Press the MUTE button on the remote control and
an icon indicating the MUTE function is active will
display on the screen. At this time, the sound of the
TV set is turned off.
To restore sound, press the MUTE button again or
press the VOL+ button.
SAP Broadcasts Setup
This TV can receive MTS stereo programs and SAP
(Secondary Audio Program) that accompanies the stereo
program if a station transmits an additional sound signal.
When the MTS button on the remote control is pressed,
the TV will only receive the signal if the TV station
transmits the proper signals.
Mono sound is automatically received if the broadcast is
only in Mono, even if Stereo or SAP has been selected.
Select Mono if you want to listen to mono sound during
stereo/SAP broadcasting. Stereo or SAP can be received
in an analog channel.
Use the MTS button to select your desired MTS
mode in an analog signal.
Each time you press the MTS button, Mono,
Stereo or SAP appear. If other languages are
available in the digital signal, select them with
the MTS button.
Press the EXIT button to save and return to TV
This TV set has two methods to set the channels:
Channel Scan and Channel Skip.
In this section, using the remote control to set the
channels is explained. You can also use the buttons
on the TV to set the channels.
The Channel Menu is only accessible when the
input source is set to TV.
Press the MENU button and then use the
button to select the TV menu.
/ ENTER button to select Antenna.
button to select Air or Cable mode.
button to select Channel Scan.
/ ENTER button to start searching.
To cancel searching, press the EXIT button.
When Air is selected, the TV will detect antenna
signals and will search for NTSC (analog) and ATSC
(digital) TV channels available in your local area.
When Cable is selected, the TV will detect signals
supplied by your cable company. It will search for
NTSC and QAM modulated channels available in
Haier LED HDTV