Speed Control Braking System; Speedcontrol System Introduction; Speedcontrol Brake Levers - Giant TRINITY ADVANCED SL Instruction Manual

Hide thumbs Also See for TRINITY ADVANCED SL:
Table of Contents

Advertisement

Speed Control braking system

SpeedControl system introduction

SpeedControl is specifically designed for the Trinity Advanced SL. It is
impossible to substitute another brake system.
WARNING
To avoid serious injury
Improper use of your bicycle's brake system may result in a loss of
control or an accident, which could lead to a severe injury. Because
each bicycle may handle differently, be sure to learn the proper braking
technique (including brake lever pressure and bicycle control
characteristics) with your Trinity Advanced SL.
Consult your bicycle dealer and practice your riding and braking
technique as necessary.

SpeedControl brake levers

WARNING
To avoid serious injury
• You must never modify the levers, otherwise the lever may break and
the brakes may no longer work as a result.
• Before riding the bicycle, check that there is no damage such as crack
or bent. If there is any damage, replace with a new part immediately
without trying to repair the damage, otherwise the lever may break and
the brakes may no longer work as a result.
• Obtain and read the service instructions carefully prior to installing the
parts.
Loose, worn or damaged parts may cause the bicycle to fall over and
serious injury may occur as a result.
• Read these Technical Service Instructions carefully, and keep them in
a safe place for later reference.
Installation instruction:
Pass the outer casing through the handlebar, and then adjust its length
so that it will fit securely into the outer casing holder when the brake
lever is installed.
Report to
Base bar cable routing
Be sure to leave some excess cable, even if cutting it to the full length of
the handlebars.
1. Install the brake lever to the handlebar by using a 5 mm Allen key to
turn it counterclockwise as shown in the illustration.
Tightening torque: 6 Nm
2. Install the inner cable. Make sure that the inner end is firmly seated in
the cable hook.
29
for additional routing instruction.
30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents