Page 3
Reign Product feature This bike is long travel XC bike. It can be go anywhere and anything. The rear suspension system is a new design which is called maestro, this maestro feature is vpp design and to get the overall suspension behavior to the best not only one point is the best . 1.
1. Sizing The actual frame measurements and geometries are listed below. 15.5〞 18〞 20〞 Size 16” 21” Top Tube (mm) Seat Tube (mm) 73.5° 73.5° 73.5° 73° 73° Seat Angle 70° 70° 70° 70° 70° Head Angle B.B. Drop (mm) Rear Center (mm) Wheel Base (mm) 1071.4...
Page 5
Air valve Rebound adjuster SPV Air Valve SPV 3 WAY SHOCK Setup SPV SET-UP QUICK REFERENCE GUIDE This quick reference guide is to be used for setting up the any Swinger shock. Follow this order to ensure the best possible tuning. * Coil and Air Shock Initial Set Up 1.
Page 6
*Note: On the 6-way shock, please make sure that the two compression adjuster knobs on the reservoir are fully open when setting the shock pressure and volume. You can turn them after you set up the pressure and volume adjuster to achieve more compression damping.
3. Torque settings The bolts used to attach the rear suspension unit are very high grade products factory installed to specific torque specification. If it becomes necessary to remove or tighten the pivot bolts extreme care should be taken when re-tightening them. All bolts should be cleaned and re-set using LocTite Primer (﹟243) All bolts location and tighten torque please refer to the illustration below.