Giant CITY SPEED - V1.0 Manual

CITY SPEED USER GUIDE VERSION 1.0
Congratulations on your purchase of a GIANT CITY SPEED.
GIANT CITY SPEED represents the latest in design and
engineering, and also requires special care. While Giant Bicycle
engineers have used the best quality, most durable and lowest
maintenance materials for this CITY SPEED, you must follow
certain guidelines to attain optimal performance and proper
wear characteristics.
!
WARNING
Failure to follow these Instructions will
void your warranty, and may result in hidden damage to
the CITY SPEED. Damage to the CITY SPEED can cause
loss of structural integrity, which may result in serious
personal injury.

Rear light

Rear light

Front light

How to replace the battery

:
Step 1
Loosen the battery holder
fixing bolt with 2.5mm Allen
Key
Fixing bolt
Battery holder
:
Step 2
-
:
Step 3
Replace the battery (AA SIZE)
+
with a new one.
+
-
!
CAUTION
The battery has polarity (+/- sides), so be
sure to install the battery as shown in the diagram.
© 2008 Giant Bicycle, Inc. Giant and its symbol are trademarks of Giant Bicycle, Inc. All rights reserved. Printed in Taiwan.
Front light
Take out the battery holder
from the stem
www.giant-bicycles.com
Rear light
How to replace the battery
:
Step 1
Loosen the battery holder fixing
bolt with 2.5mm Allen key
Tightening torque:
9.8-11.7 Nm (87-103 In. lbs.)
:
Step 2
Replace the battery (CR2032)
with a new one
!
WARNING
Full composite seat post is NOT
applicable due to the integrated design of seat clamp.
Rear light on the rear carrier:
:
Step 1
Loosen the battery holder fixing
bolt with 2.5mm Allen key
: Replace the battery (CR2032) with a new one
Step 2
!
CAUTION
The battery has polarity (+/- sides), so be
sure to install the battery with the + side upward as
shown in the diagram.

Handlebar

Handlebar alignment:

:
Step 1 Loosen the handlebar binder bolt
with 6mm Allen key to make sure
the handlebar stem is parallel to
the bike's center line and
clamped tight enough so that you
can't twist it out of alignment
Tightening torque: 11.7-14.7 Nm (104-130 In. lbs.)
!
CAUTION
An insufficiently tightened handlebar
binder bolt may compromise steering action, which
control and fall. Place the
could cause you to lose
front wheel of the bicycle between your legs and
attempt to twist the handlebar/stem assembly. If
you can twist the stem in relation to the front
wheel, the bolts are insufficiently tightened.
.

Warranty

Please refer to the Giant Owner's Manual for complete
provisions of the warranty.