Advertisement
The convector TCH 1 E is used to generate warm air for interior spaces.
The device generates heat by means of an electric heating element. The air surrounding the heating element is heated. The heated air rises through the air outlet and thus enters the room. The device is equipped with an integrated thermostat and so generates a constant flow of warm air.
The device is not suitable for wall mounting.
No. | Designation |
1 | Air outlet |
2 | Transport handle |
3 | Air inlet |
4 | Rotary switch room thermostat |
5 | Operating control lamp |
6 | Foot |
Note
If you store or transport the device improperly, the device may be damaged.
Note the information regarding transport and storage of the device.
To make the device easier to transport, it is fitted with a carry handle.
Before transporting the device, observe the following:
Before storing the device, proceed as follows:
When the device is not being used, observe the following storage conditions:
Info
The device is not suitable for wall mounting.
Mounting the feet
Mount the feet before positioning the device.
Info
Odours might arise upon initial start-up or after a longer period of non-use.
When positioning the device, observe the minimum distance from walls or other objects as described in the chapter Technical annex.
Connecting the power cable
Operating elements
No. | Designation |
4 | Rotary switch room thermostat |
Switching the device on
Once you have completely installed the device as described in the Start-up chapter, you can switch it on.
Setting the room thermostat
To find the ideal thermostat setting, please proceed as follows:
Frost monitor function:
Shutdown
of electrical voltage
Do not touch the mains plug with wet or damp hands.
of electrical voltage
Tasks which require the device to be opened must only be carried out by authorised specialist companies or by Trotec.
The device has been checked for proper functioning several times during production. If malfunctions occur nonetheless, check the device according to the following list. The device does not start:
The device still does not operate correctly after these checks:
Please contact the customer service. If necessary, bring the device to an authorised specialist electrical company or to Trotec for repair.
Activities required before starting maintenance
of electrical voltage
Do not touch the mains plug with wet or damp hands.
of electrical voltage
Tasks which require the device to be opened must only be carried out by authorised specialist companies or by Trotec.
of electrical voltage Never immerse the device in water!
Clean the housing with a soft, damp and lint-free cloth. Ensure that no moisture enters the housing. Protect electrical components from moisture. Do not use any aggressive cleaning agents such as cleaning sprays, solvents, alcohol-based or abrasive cleaners to dampen the cloth. Wipe the housing dry after cleaning.
Technical data
Parameter | Value |
Model | TCH 1 E |
Heating capacity | 450 W |
Mains connection | 220 – 240 V~50 Hz |
Power consumption | 0.45 kW |
Nominal current | 2 A |
consumption | |
Fusing | 10 A |
Plug type | Schuko plug CEE 7/7 |
Cable length | 1.2 m |
Dimensions (length x width x height) | 177 x 275 x 276 mm |
Minimum distance to walls and other objects top (A): rear (B): sides (C): front (D): | 100 cm 50 cm 50 cm 50 cm |
Weight | 1 kg |
Information requirements for electrical local space heaters
Parameter | Value / item |
Model | TCH 1 E |
Heat output | |
Nominal heat output Pnom | 0.40 – 0.45 kW |
Minimum heat output (indicative) Pmin | 0.40 kW |
Maximum continuous heat output Pmax, c | 0.45 kW |
Auxiliary electricity consumption | |
At nominal heat output elmax | NA |
At minimum heat output elmin | NA |
In standby mode elsb | NA |
Type of heat input | |
Manual heat charge control, with integrated thermostat | NA |
Manual heat charge control with room and/or outdoor temperature feedback | NA |
Electronic heat charge control with room and/or outdoor temperature feedback | NA |
Fan assisted heat output | NA |
Type of heat output/room temperature control | |
Single stage heat output, no room temperature control | NO |
Two or more manual stages, no room temperature control | NO |
With mechanic thermostat room temperature control | YES |
With electronic room temperature control | NO |
With electronic room temperature control plus day timer | NO |
With electronic room temperature control plus week timer | NO |
Other control options | |
Room temperature control, with presence detection | NO |
Room temperature control, with open window detection | NO |
With distance control option | NO |
With adaptive start control | NO |
With working time limitation | NO |
With black bulb sensor | NO |
Contact details | Trotec GmbH Grebbener Straße 7 D-52525 Heinsberg |
NA: not applicable
Trotec GmbH
Grebbener Str. 7
D-52525 Heinsberg
+49 2452 962-400
+49 2452 962-200
info@trotec.com
www.trotec.com
Symbols
of electrical voltage This symbol indicates dangers to the life and health of persons due to electrical voltage | |
| of hot surface This symbol indicates dangers to the life and health of persons due to hot surface. |
| This signal word indicates a hazard with an average risk level which, if not avoided, can result in serious injury or death. |
| This signal word indicates a hazard with a low risk level which, if not avoided, can result in minor or moderate injury. Note This signal word indicates important information (e.g. material damage), but does not indicate hazards. |
| Info Information marked with this symbol helps you to carry out your tasks quickly and safely. |
![]() | Follow the manual Information marked with this symbol indicates that the operating manual must be observed. |
You can download the current version of the operating manual and the EU declaration of conformity via the following link:
https://hub.trotec.com/?id=42755
Read this manual carefully before starting or using the device. Always store the manual in the immediate vicinity of the device or its site of use.
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Children of less than 3 years should be kept away from the device unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
Do not use the device in small rooms if persons are present who cannot leave the room independently and who are not under constant supervision.
Intended use
The device is only suitable for well insulated spaces or occasional use.
Only use the device for heating closed rooms whilst adhering to the technical data.
Intended use comprises heating the air in:
Foreseeable misuse
People who use this device must:
Maintenance tasks which require the housing to be opened must only be carried out by specialist electrical companies or by Trotec.
Symbols | Meaning |
![]() | This symbol located on the device indicates that it is prohibited to place objects (such as towels, clothes etc.) above or directly in front of the device. In order to avoid overheating and fire hazards, the heater must not be covered. |
Residual risks
of electrical voltage
Work on the electrical components must only be carried out by an authorised specialist company!
of electrical voltage
Before any work on the device, remove the mains plug from the mains socket! Do not touch the mains plug with wet or damp hands. Hold onto the mains plug while pulling the power cable out of the mains socket.
of hot surface
Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present!
Improper handling entails a risk of burning and electric shock. Only use the device as intended!
Dangers can occur at the device when it is used by untrained people in an unprofessional or improper way! Observe the personnel qualifications!
The device is not a toy and does not belong in the hands of children.
Risk of suffocation!
Do not leave the packaging lying around. Children may use it as a dangerous toy.
Improper installation entails a risk of fire. Do not place the device on combustible ground. Do not place the device on high-pile carpets.
In order to avoid overheating and fire hazards, the device must not be covered!
The device is provided with a safety thermostat which is activated by overheating of the device:
When the safety thermostat is activated, allow the device to cool down. Only then start to look for the cause of overheating. Should the problem persist, please contact the customer service.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the TCH 1 E and is the answer not in the manual?
Questions and answers