Section 3 - Configuration
Choose PPTP (Point-to-Point-Tunneling Protocol ) if your ISP uses a PPTP connection. Your ISP will provide you with
a username and password. This option is typically used for DSL services.
PPTP:
Select Dynamic (most common) or Static. Select Static if
your ISP assigned you the IP address, subnet mask, gateway,
and DNS server addresses.
IP Address:
Enter the IP address (Static PPTP only).
Subnet Mask:
Enter the Primary and Secondary DNS Server Addresses
(Static PPTP only).
Gateway:
Enter the Gateway IP Address provided by your ISP.
DNS:
The DNS server information will be supplied by your ISP
(Internet Service Provider.)
Server IP:
Enter the Server IP provided by your ISP (optional).
PPTP Account:
Enter your PPTP account name.
PPTP Password:
Enter your PPTP password and then retype the password
in the next box.
Maximum Idle
Enter a maximum idle time during which the Internet
Time:
connection is maintained during inactivity. To disable this
feature, enable Auto-reconnect.
MTU:
Maximum Transmission Unit - You may need to change the
MTU for optimal performance.
Connect Mode:
Select either Always-on, Manual, or Connect-on demand.
D-Link DIR-600 User Manual
Internet Setup
PPTP
22