FUTABA 12Z Series Instruction Manual page 13

•Removing and storing the antenna
When removing the antenna from the antenna
compartment, hold the transmitter level so that
When storing the antenna, push the antenna in
until it is locked positively
•Mounting and dismounting the antenna
Mount the antenna by turning it clockwise until
it locks in place.
Clockwise
• When dismounting the antenna, turn the
antenna counterclockwise
•Angle adjustment of the antenna
You can change the angle of the antenna, as
you like. Use 2.5mm hexagonal wrench to turn
counterclockwise to release the screw on the left
of the antenna holder, and change the angle of the
antenna, as you like, then retighten.
LED monitor
The color of the 12Z logo mark shows the status
of the transmitter.
(LED Display)
• When you turn on the transmitter, 12Z logo
shows different colors, and then the color
stays constantly pink. The 12Z logo blinks
green very rapidly while internal processing
is carried out after the power is turned on.
Once the internal processing is over, the logo
turns to pink color.
• The 12Z logo turns blue when you use the DSC
cable, or when the trainer function is set at
student's side.
• The 12Z logo blinks red slowly when you
attach the RF module that is different from
the setting.
• Under the normal usage (, that is, radio wave
is being emitted), the 12Z logo turns green.
Switch (SA-SH)
(Switch Type)
• SA : 3 positions; Alternate; Short lever
• SB : 3 positions; Alternate; Long lever
• SC : 3 positions; Alternate; Long lever
• SD : 3 positions; Alternate; Short lever
• SE : 3 positions; Alternate; Short lever
• SF : 2 positions; Alternate; Long lever
• SG : 2 positions; Alternate; Short lever
• SH : 2 positions; Momentary; Long lever
*You can choose switch and set the ON/OFF-direction in the
setting screen of the mixing functions.
<Before Use> 13