Installation Instructions; Tools And Parts; Custom Overlay Frame - KitchenAid KBCO24LS - 24 in. Undercounter Wine Cellar Use And Care Manual

Tools and Parts

TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Hand drill or electric drill
(properly grounded)
" Brad point doweling
drill bit
Phillips screwdriver
PARTS NEEDED:
Custom Overlay Frame—See "Overlay Frame—Rear View."
Hardware (Optional)
PARTS SUPPLIED:
Flat-head screws (8)
Round-head screws (8)

Custom Overlay Frame

If you plan to install a custom overlay frame, you will need to
create the frame yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for frame specifications.
IMPORTANT:
The thickness of the overlay frame must be
Overlay frame must not weigh more than 10 lbs (4.54 kg).
Overlay frames weighing more than recommended may
cause damage to your appliance.
Overlay Frame Dimensions—Rear View
Create the custom overlay frame using the dimensions shown.
1 "
4 "
(3.33 cm)
(11.2 cm)
2 "
A
(7.5 cm)
1 "
2 "
(3.33 cm)
(6.4 cm)
A. Overlay hook locations
4

INSTALLATION INSTRUCTIONS

Scissors
Masking tape
Tape measure
Petroleum jelly
Overlay plates (2)
Overlay hooks (4)
" (1.91 cm).
3 "
(9.53 cm)
23 "
(60.33 cm)
Install Overlay Hooks
Using a Phillips screwdriver and eight flat-head screws, attach the
overlay hooks to the back of the overlay frame. See "Overlay
Frame–Rear View" for overlay hook locations.
Door Hinge Holes
The views of the top and bottom hinge pin hole show a right-
hand hinge. Mirror the image for a left-hand hinge.
We recommend using a C-clamp and two pieces of scrap
wood (front and back) to help reinforce the overlay frame
when drilling the hinge pin holes.
1. Using a " Brad point doweling drill bit, drill a
deep hole into the top of the overlay frame for the top hinge
pin as shown.
29 "
(75.88 cm)
(1.35 mm)
A. Overlay hooks (4)
Top View
"
(1.2 cm)
A
Front Surface
"
Back Surface
A. Radius 5.0
A
" (1.27 cm)