Draining; Drain Valve Washer Replacement; Service - Kenmore 33205 - Power Vent, 50 Gallon Owner's Manual

TEMPERATURE-PRESSURE
DISCHARGE PIPE
FIGURE 30.
When checking the temperature-pressure relief valve operation, make
sure that (1) no one is in front of or around the outlet of the temperature-
pressure relief valve discharge line, and (2) that the water discharge will
not cause any property damage, as the water may be extremely hot,
see Figure 30.
If after manually operating the valve, it fails to completely reset and
continues to release water, immediately close the cold water inlet
to the water heater, follow the draining instructions, and replace the
temperature-pressure relief valve with a new one.
If the temperature-pressure relief valve on the appliance weeps or
discharges periodically, this may be due to thermal expansion. You
may have a check valve installed in the water line or a water meter
with a check valve. Consult your local water supplier or Sears Service
Center for further information. Do not plug the temperature-pressure
relief valve.
DRAINING
• Burn hazard
• Hotwater discharge.
• Keep hands clear of drain
valve discharge.
The water heater should be drained if being shut down during freezing
temperatures. Also periodic draining and cleaning of sediment from the
tank may be necessary.
1. Set the blower switch to the "OFF" position.
2. CLOSE the cold water inlet valve to the water heater.
3. OPEN a nearby hot water faucet and leave open to allow for
draining.
4. Connect a hose to the drain valve and terminate to an adequate
drain.
5. OPEN the water heater drain valve to allow for tank draining.
NOTE: If the water heater is going to be shut down and drained
for an extended period, the drain valve should be left open with
hose connected allowing water to terminate to an adequate
drain,
6. CLOSE the drain valve.
7. Follow instructions in the "Filling The Water Heater" section.
8. Follow the lighting instructions on the label or see page 22 under
"Operating Instructions" to restart the water heater.
DRAIN VALVE WASHER REPLACEMENT
(See Figure 31 )
1. Turn "OFF" gas supply to water heater.
2. Follow "Draining" instructions.
3. Turning counterclockwise ( _ ), remove the hex cap below the
screw handle.
4. Remove the washer and put the new one in place.
5. Screw the handle and cap assembly back into the drain valve and
retighten using a wrench. DO NOT OVER TIGHTEN.
6. Follow instructions in the "Filling The Water Heater" section.
7. Check for leaks.
8. Follow the lighting instructions in the "Operating Instructions" section
to restart the water heater.
SERVICE
_HANDLE AND
CAP ASSEMBLY
WASHER
FIGURE 31.
If a condition persists or you are uncertain about the operation of
the water heater contact Sears Service Center at 1-800-MY-HOME ®
(1-800-469-4663).
28